|Warranty length||2 Years|
Power Out: >55W (8Ω), >85W (4Ω)
Cont. Current: >8.5 Amps (sin wave)
Max Current: +/- 26 Amps, (burst 0.5Ω)
Output Impedance: <0.1Ω @1KHz
THD: < 0.005%, 20Hz – 20KHz
Freq Resp: 10Hz–100KHz +/- 2dB Line
Gain: 33.3dB (x46)
Input Sensitivity: 410mV
Input Impedance: 47kΩ unbal, 30kΩ bal
Crosstalk: -80dB at 1Khz
DC Offset: < +/-10mV
Slew Rate: >30 V per uS
Inputs: RCA unbal, XLR balanced
Outputs: Pair of HQ binding posts
Operating: 110V/230V Switchable
Consumption (Idle): <20 Watts
Consumption (Max): 350 Watts
Dimensions (WHD): 430 x 60 x 280mm
Weight: 7.5 Kg
reek 50P Power amplifier can be added to the Creek Evolution 50A integrated amplifier as an upgrade to biamp your system for powering difficult loudspeaker loads or alternatively it can be used with any good pre amplifier.
This new 55W (into 8 Ohms) power amplifier forms part of the new generation Evolution 50 range of products. Housed in a slim case with engraved front panel and solid control knobs, it’s finished with either a black or silver brushed aluminium front panel.
A simple unity gain pre-amplifier selects between balanced XLR and direct un-balanced RCA inputs, to enable the user to input two different signals and easily select between either. It is fully protected from over-current, over-temperature and DC faults and will trigger the output and input relays to disengage immediately if an error occurs.
Class A/B Power
This power amplifier has a similar high-end, bi-polar transistor, Class-A/B power amplifier circuit, to the highly rated Evolution 50A, also developed by David Gamble. It achieves very high open-loop gain and low distortion for a smooth and powerful sound.
Using a massive 200 watt toroidal transformer, the Evolution 50P has separate windings for high and low current analogue and control circuitry. This solution produces a good power to weight ratio and low magnetic interference.
Creek’s design policy of connecting several small low impedance capacitors in parallel creates an ultra-high spec capacitor to smooth the DC and helps to produce a very powerful and accurate sound from such a relatively small amplifier.
Creek Evolution 50P utilises a a pair of Sanken 15 Amp power transistors with built-in thermal compensation for rapid bias tracking performance. The circuit has very low output impedance and the ability to deliver high output current. This combination provides exceptional speed and control over most loudspeakers.